Seadoo GTX/GTI 1996+ Standard Cover

111WS102

New product

An economical fitted storage cover to suit early GTX and GTI 2 stroke models - see application chart. 

This product is no longer in stock

$ 249.00

****  Photo is generic and shows general style only.  Actual cover is specific for the models in the application chart below only.

 

A good storage cover is essential to protect your Seadoo watercraft while it is stored.

The cover is made of 600D solution dyed polyester, which means the color goes all the way through and is much more fade resistant than other covers. Each Seadoo Jet Ski cover comes with a tie down strap kit for trailering and a storage bag to keep you Seadoo Cover in while you are out riding.

The Seadoo covers work great for indoor and outdoor storage applications and the 600D material is breathable to help prevent mildew growth and allow moisture to evaporate.

All Seadoo covers come in a Black and Gray 2-tone color pattern.

Seadoo covers have a 1 year warranty against defects in workmanship or material.


Applications:

Will NOT fit 2002 GTX DI or GTX 4 Tec.

1996 GTX
1997 GTX
1998 GTX LIMITED
1998 GTX RFI
1999 GTX LIMITED
1999 GTX RFI
2000 GTX
2000 GTX DI
2000 GTX RFI
2001 GTX
2001 GTX DI
2001 GTX RFI
2002 GTX
2002 GTX RFI

1997 GTI
1998 GTI
1999 GTI
2000 GTI
 
 
Important Usage Tips:
 
This is a model specific fitted cover which can be used for towing short distances.
 
Always allow the ski to completely cool down, remove water from foot wells and allow the engine bay to dry out before putting the cover on. 
 
If the ski is being stored outside, remove the cover and check periodically.
 
Never fold a wet/damp cover to store as it will become moldy.
Watercraft Superstore covers have a 1 year manufacturer's warranty against defect in material and workmanship. This warranty does not cover fading, tearing or stains which are likely during normal use. Environments with extreme weather conditions might have an adverse effect on the longevity of the material which will not be covered under warranty.

If you should have a problem or questions, please contact SBT @877-330-0231 or sales@SBT.com
Your new Watercraft Superstore cover is designed to give years of protection to your PWC. To install the cover, it is best to start at the handle bars and mirrors (if equipped) then pull the cover forward over the bow and rearward over the stern of the craft.

The shock cord installed at the hem of the cover should be pulled down under the rub rail of the PWC. Most covers will hold in place with just the use of the shock cord for stationary storage.

If the craft is going to be towed or is stored in an area that gets high winds, we suggest using the provided tie down straps to wrap under the PWC to secure the cover.
The watercraft should always be clean before installing any cover to prevent damage to the finish.
 
 
 
$ 24.95
This Bilge Sponge is a special tool in the maintenance kit - it has the ability to suck up a monsterous...
$ 44.95
1 litre of concentrated flush additive for flushing all jetski's which have been used in salt water.